|
|
Marsili, F., Bitauld, D., Fiore, A., Gaggero, A., Leoni, R., Mattioli, F., et al. (2009). Superconducting parallel nanowire detector with photon number resolving functionality. J. Modern Opt., 56(2-3), 334–344.
Abstract: We present a new photon number resolving detector (PNR), the Parallel Nanowire Detector (PND), which uses spatial multiplexing on a subwavelength scale to provide a single electrical output proportional to the photon number. The basic structure of the PND is the parallel connection of several NbN superconducting nanowires (100 nm-wide, few nm-thick), folded in a meander pattern. Electrical and optical equivalents of the device were developed in order to gain insight on its working principle. PNDs were fabricated on 3-4 nm thick NbN films grown on sapphire (substrate temperature TS=900C) or MgO (TS=400C) substrates by reactive magnetron sputtering in an Ar/N2 gas mixture. The device performance was characterized in terms of speed and sensitivity. The photoresponse shows a full width at half maximum (FWHM) as low as 660ps. PNDs showed counting performance at 80 MHz repetition rate. Building the histograms of the photoresponse peak, no multiplication noise buildup is observable and a one photon quantum efficiency can be estimated to be QE=3% (at 700 nm wavelength and 4.2 K temperature). The PND significantly outperforms existing PNR detectors in terms of simplicity, sensitivity, speed, and multiplication noise.
|
|
|
|
Ожегов, Р. В., Окунев, О. В., Гольцман, Г. Н., Филиппенко, Л. В., & Кошелец, В. П. (2009). Флуктуационная чувствительность сверхпроводящего интегрального приемника терагерцового диапазона частот. Радиотех. электроник., 54(6), 750–755.
Abstract: Исследована зависимость флуктуационной чувствительности сверхпроводящего интегрального приемника (СИП) от шумовой температуры приемника и величины входного сигнала. Измерена рекордная флуктуационная чувствительность приемника (13 ± 2 мК), полученная при шумовой температуре приемника 200 К, ширине полосы промежуточных частот 4 ГГц и постоянной времени 1 с. При уменьшении входного сигнала наблюдалось улучшение флуктуационной чувствительности; предложено обÑŠяснение полученного эффекта: причиной является уменьшение влияния нестабильностей источников питания приемника и усилительного тракта при снижении входного сигнала.
|
|
|
|
Смирнов, А. В. (2009). Исследование полосы преобразования терагерцовых смесителей на эффекте электронного разогрева в NbZr, NbN и в одиночном гетеропереходе AlGaAs/GaAs.
|
|
|
|
Lobanov, Y., Tong, C., Blundell, R., & Gol'tsman, G. (2009). A study of direct detection effect on the linearity of hot electron bolometer mixers. In Proc. 20th Int. Symp. Space Terahertz Technol. (pp. 282–287).
Abstract: We have performed a study of how direct detection affects the linearity and hence the calibration of an HEB mixer. Two types of waveguide HEB devices have been used: a 0.8 THz HEB mixer and a 1.0 THz HEB mixer which is ~5 times smaller than the former. Two independent experimental approaches were used. In the ΔG/G method, the conversion gain of the HEB mixer is first measured as a function of the bias current for a number of bias voltages. At each bias setting, we carefully measure the change in the operating current when the input loads are switched. From the measured data, we can derive the expected difference in gain between the hot and cold loads. In the second method (injection method [1]), the linearity of the HEB mixer is independently measured by injecting a modulated signal for different input load temperatures. The results of both approaches confirm that there is gain compression in the operation of HEB mixers. Based on the results of our measurements, we discuss the impact of direct detection effects on the operation of HEB mixers.
|
|
|
|
Gol'tsman, B. M., Kutasov, V. A., & Luk'yanova, L. N. (2009). Mechanism of formation of texture and its influence on the strength of thermoelectric p-Bi0.5Sb1.5Te3. Phys. Sol. St., 51(4), 747–749.
Abstract: It is established that, in preparing p-Bi0.5Sb1.5Te3 by vertical zone melting, in addition to the directional texture (characteristic of materials exhibiting a highly anisotropic growth rate) in which the cleavage planes of crystal grains are parallel to the direction of propagation of the crystallization front, other texture types can arise, in which the orientation of grain cleavage planes is ordered in a cross-sectional plane of the ingot. Two types of such textures, “radial†and “circular,†were observed. In a radial texture, the lines of intersection of grain cleavage planes with a cross-sectional plane of the ingot are oriented along radii of this cross section and, in a circular texture, these lines of intersection are oriented approximately perpendicular to a radius crossing the grain. The formation of a radial texture is associated with rotation of the ampoule with the crystallizing substance about its vertical axis causing centrifugal flows of the melt. The formation of a circular texture is associated with the orientation effect of the ampoule walls and with circular motion of the melt during torsional oscillations of the ampoule about the vertical axis. Ingots with a radial texture exhibit much lower resistance to splitting along their axis than ingots with a circular texture do. An explanation is provided for this fact.
|
|
