Venediktov IO, Elezov MS, Prokhodtsov AI, Kovalyuk VV, An PP, Golikov AD, et al. Study of microheater’s phase modulation for on-chip Kennedy receiver. In: J. Phys.: Conf. Ser. Vol 1695.; 2020. 012117.
Abstract: In this work we describe phase modulators for several Mach-Zehnder interferometers (MZI) on silicon nitride platform for telecomm wavelength (1550 nm). We obtained current-voltage and phase-voltage curves for these modulators. MZI are needed for experimental realisation of various quantum receivers that can distinguish weak coherent states of light with extremely low error. Thermo-optical (TO) modulation is ensured by microheaters on one of the arms of MZI, which enables the change of the refractive index of the material with temperature. This approach allows to apply the necessary voltage to the golden microheaters to obtain the required phase change. For the on-chip microheaters we demonstrate the dependence of the phase shift on the voltage applied to our on-chip microheaters.
|
Zubkova E, Golikov A, An P, Kovalyuk V, Korneev A, Ferrari S, et al. CWDM demultiplexer using anti-reflection, contra-directional couplers based on silicon nitride rib waveguide. In: J. Phys.: Conf. Ser. Vol 1410.; 2019. 012179.
Abstract: We report on the development and fabrication of a 9-channel coarse wavelength-division multiplexing for telecommunication wavelengths (1550 nm) using anti-reflection contra-directional couplers, based on silicon nitride (Si3N4) rib waveguide. The transmitted and reflected spectrum in each channel of the demultiplexer were measured. The average full width at half maximum of the transmitted (reflected) spectra is about 3 nm.
|
Kuzin A, Kovalyuk V, Golikov A, Prokhodtsov A, Marakhin A, Ferrari S, et al. Efficiency of focusing grating couplers versus taper length and angle. In: J. Phys.: Conf. Ser. Vol 1410.; 2019. 012181.
Abstract: Here we experimentally studied dependence of a focusing grating coupler efficiency versus taper length and angle on silicon nitride platform. As a result, we obtained a dependence for the efficiency of a focusing grating coupler on the parameters of the taper length and angle.
|
Prokhodtsov A, Golikov A, An P, Kovalyuk V, Goltsman G, Arakelyan S, et al. Effect of silicon oxide coating on a silicon nitride focusing grating coupler efficiency. In: EPJ Web Conf. Vol 220.; 2019. 02009.
Abstract: The dependence of the efficiency of the focusing grating couplers on the period and filling factor before and after deposition of the upper silicon oxide layer was experimentally studied. The obtained data are of practical importance for tunable integrated-optical devices based on silicon nitride platform.
|
Elmanov I, Elmanova A, Komrakova S, Golikov A, Kaurova N, Kovalyuk V, et al. Method for determination of resists parameters for photonic – integrated circuits e-beam lithography on silicon nitride platform. In: EPJ Web Conf. Vol 220.; 2019. 03012.
Abstract: In the work the thicknesses of the e-beam resists ZEP 520A and ma-N 2400 by using non-destructive method were measured, as well as recipe for the high ratio between the Si3N4 and the resists etching rate was determined. The work has a practical application for e-beam lithography of photonic-integrated circuits and nanophotonics devices based on silicon nitride platform.
|
