| Home | << 1 2 3 4 >> |
|
| Records | |||||
|---|---|---|---|---|---|
| Author | Meledin, D.; Tong, C.-Y. E.; Blundell, R.; Goltsman, G. | ||||
| Title | Measurement of intermediate frequency bandwidth of hot electron bolometer mixers at terahertz frequency range | Type | Journal Article | ||
| Year | 2003 | Publication  |
IEEE Microw. Wireless Compon. Lett. | Abbreviated Journal | IEEE Microw. Wireless Compon. Lett. |
| Volume | 13 | Issue | 11 | Pages | 493-495 |
| Keywords | waveguide NbN HEB mixers | ||||
| Abstract | We have developed a new experimental setup for measuring the IF bandwidth of superconducting hot electron bolometer mixers. In our measurement system we use a chopped hot filament as a broadband signal source, and can perform a high-speed IF scan with no loss of accuracy when compared to coherent methods. Using this technique we have measured the 3 dB IF bandwidth of hot electron bolometer mixers, designed for THz frequency operation, and made from 3-4 nm thick NbN film deposited on an MgO buffer layer over crystalline quartz. | ||||
| Address | |||||
| Corporate Author | Thesis | ||||
| Publisher | Place of Publication | Editor | |||
| Language | Summary Language | Original Title | |||
| Series Editor | Series Title | Abbreviated Series Title | |||
| Series Volume | Series Issue | Edition | |||
| ISSN | 1531-1309 | ISBN | Medium | ||
| Area | Expedition | Conference | |||
| Notes | Approved | no | |||
| Call Number | Serial | 1509 | |||
| Permanent link to this record | |||||
| Author | Tong, C.-Y. E.; Meledin, D.; Loudkov, D.; Blundell, R.; Erickson, N.; Kawamura, J.; Mehdi, I.; Gol’tsman, G. | ||||
| Title | A 1.5 THz Hot-Electron Bolometer mixer operated by a planar diode based local oscillator | Type | Conference Article | ||
| Year | 2003 | Publication |
IEEE MTT-S Int. Microwave Symp. Digest | Abbreviated Journal | IEEE MTT-S Int. Microwave Symp. Digest |
| Volume | 2 | Issue | Pages | 751-754 | |
| Keywords | waveguide NbN HEB mixers | ||||
| Abstract | We have developed a 1.5 THz superconducting NbN Hot-Electron Bolometer mixer. It is operated by an all-solid-state Local Oscillator comprising of a cascade of 4 planar doublers following an MMIC based W-band power amplifier. The threshold available pump power is estimated to be 1 /spl mu/W. | ||||
| Address | Philadelphia, PA, USA | ||||
| Corporate Author | Thesis | ||||
| Publisher | Place of Publication | Editor | |||
| Language | Summary Language | Original Title | |||
| Series Editor | Series Title | Abbreviated Series Title | |||
| Series Volume | Series Issue | Edition | |||
| ISSN | ISBN | Medium | |||
| Area | Expedition | Conference | |||
| Notes | Approved | no | |||
| Call Number | Serial | 1516 | |||
| Permanent link to this record | |||||
| Author | Trifonov, A.; Tong, C.-Y. E.; Blundell, R.; Ryabchun, S.; Gol'tsman, G. | ||||
| Title | Probing the stability of HEB mixers with microwave injection | Type | Journal Article | ||
| Year | 2015 | Publication |
IEEE Trans. Appl. Supercond. | Abbreviated Journal | IEEE Trans. Appl. Supercond. |
| Volume | 25 | Issue | 3 | Pages | 2300404 (1 to 4) |
| Keywords | NbN HEB mixer, stability, Allan-variance | ||||
| Abstract | Using a microwave probe as a tool, we have performed experiments aimed at understanding the origin of the output-power fluctuations in hot-electron-bolometer (HEB) mixers. We use a probe frequency of 1.5 GHz. The microwave probe picks up impedance changes of the HEB, which are examined upon demodulation of the reflected wave outside the cryostat. This study shows that the HEB mixer operates in two different regimes under a terahertz pump. At a low pumping level, strong pulse modulation is observed, as the device switches between the superconducting state and the normal state at a rate of a few megahertz. When pumped much harder, to approximate the low-noise mixer operating point, residual modulation can still be observed, showing that the HEB mixer is intrinsically unstable even in the resistive state. Based on these observations, we introduced a low-frequency termination to the HEB mixer. By terminating the device in a 50-Ω resistor in the megahertz frequency range, we have been able to improve the output-power Allan time of our HEB receiver by a factor of four to about 10 s for a detection bandwidth of 15 MHz, with a corresponding gain fluctuation of about 0.035%. | ||||
| Address | |||||
| Corporate Author | Thesis | ||||
| Publisher | Place of Publication | Editor | |||
| Language | Summary Language | Original Title | |||
| Series Editor | Series Title | Abbreviated Series Title | |||
| Series Volume | Series Issue | Edition | |||
| ISSN | 1051-8223 | ISBN | Medium | ||
| Area | Expedition | Conference | |||
| Notes | Approved | no | |||
| Call Number | Serial | 1355 | |||
| Permanent link to this record | |||||
| Author | Trifonov, A.; Tong, C.-Y. E.; Grimes, P.; Lobanov, Y.; Kaurova, N.; Blundell, R.; Goltsman, G. | ||||
| Title | Development of A Silicon Membrane-based Multi-pixel Hot Electron Bolometer Receiver | Type | Conference Article | ||
| Year | 2017 | Publication |
IEEE Trans. Appl. Supercond. | Abbreviated Journal | IEEE Trans. Appl. Supercond. |
| Volume | 27 | Issue | 4 | Pages | 6 |
| Keywords | Multi-pixel, HEB, silicon-on-insulator, horn array | ||||
| Abstract | We report on the development of a multi-pixel Hot Electron Bolometer (HEB) receiver fabricated using silicon membrane technology. The receiver comprises a 2 × 2 array of four HEB mixers, fabricated on a single chip. The HEB mixer chip is based on a superconducting NbN thin film deposited on top of the silicon-on-insulator (SOI) substrate. The thicknesses of the device layer and handling layer of the SOI substrate are 20 μm and 300 μm respectively. The thickness of the device layer is chosen such that it corresponds to a quarter-wave in silicon at 1.35 THz. The HEB mixer is integrated with a bow-tie antenna structure, in turn designed for coupling to a circular waveguide, |
||||
| Address | |||||
| Corporate Author | Thesis | ||||
| Publisher | Place of Publication | Editor | |||
| Language | Summary Language | Original Title | |||
| Series Editor | Series Title | Abbreviated Series Title | |||
| Series Volume | Series Issue | Edition | |||
| ISSN | ISBN | Medium | |||
| Area | Expedition | Conference | |||
| Notes | Approved | no | |||
| Call Number | RPLAB @ kovalyuk @ | Serial | 1111 | ||
| Permanent link to this record | |||||
| Author | Trifonov, A.; Tong, C.-Y. E.; Grimes, P.; Lobanov, Y.; Kaurova, N.; Blundell, R.; Goltsman, G. | ||||
| Title | Development of a silicon membrane-based multipixel hot electron bolometer receiver | Type | Journal Article | ||
| Year | 2017 | Publication |
IEEE Trans. Appl. Supercond. | Abbreviated Journal | IEEE Trans. Appl. Supercond. |
| Volume | 27 | Issue | 4 | Pages | 1-5 |
| Keywords | Multi-pixel, NbN HEB, silicon-on-insulator, horn array | ||||
| Abstract | We report on the development of a multipixel hot electron bolometer (HEB) receiver fabricated using silicon membrane technology. The receiver comprises a 2 × 2 array of four HEB mixers, fabricated on a single chip. The HEB mixer chip is based on a superconducting NbN thin-film deposited on top of the silicon-on-insulator (SOI) substrate. The thicknesses of the device layer and handling layer of the SOI substrate are 20 and 300 μm, respectively. The thickness of the device layer is chosen such that it corresponds to a quarter-wave in silicon at 1.35 THz. The HEB mixer is integrated with a bow-tie antenna structure, in turn designed for coupling to a circular waveguide, fed by a monolithic drilled smooth-walled horn array. | ||||
| Address | |||||
| Corporate Author | Thesis | ||||
| Publisher | Place of Publication | Editor | |||
| Language | Summary Language | Original Title | |||
| Series Editor | Series Title | Abbreviated Series Title | |||
| Series Volume | Series Issue | Edition | |||
| ISSN | 1051-8223 | ISBN | Medium | ||
| Area | Expedition | Conference | |||
| Notes | Approved | no | |||
| Call Number | Serial | 1324 | |||
| Permanent link to this record | |||||