%0 Conference Proceedings
%T Fabrication and characterisation of NbN HEB mixers with in situ gold contacts
%A Ryabchun, S. A.
%A Tretyakov, I. V.
%A Finkel, M. I.
%A Maslennikov, S. N.
%A Kaurova, N. S.
%A Seleznev, V. A.
%A Voronov, B. M.
%A Goltsman, G. N.
%S Proc. 19[super:th] Int. Symp. Space Terahertz Technol.
%D 2008
%C Groningen, Netherlands
%F Ryabchun_etal2008
%O exported from refbase (https://db.rplab.ru/refbase/show.php?record=412), last updated on Sat, 15 May 2021 23:21:25 -0500
%X We present our recent results of the fabrication and testing of NbN hot-electron bolometer mixers with in situ gold contacts. An intermediate frequency bandwidth of about 6 GHz has been measured for the mixers made of a 3.5-nm NbN film on a plane Si substrate with in situ gold contacts, compared to 3.5 GHz for devices made of the same film with ex situ gold contacts. The increase in the intermediate frequency bandwidth is attributed to additional diffusion cooling through the improved contacts, which is further supported by the its dependence on the bridge length: intermediate frequency bandwidths of 3.5 GHz and 6 GHz have been measured for devices with lengths of 0.35 μm and 0.16 μm respectively at a local oscillator frequency of 300 GHz near the superconducting transition. At a local oscillator frequency of 2.5 THz the receiver has offered a DSB noise temperature of 950 K. When compared to the previous result of 1300 K obtained at the same local oscillator frequency for devices fabricated with an ex situ route, such a low value of the noise temperature may also be attributed to the improved gold contacts.
%K HEB
%K mixer
%K NbN
%K in-situ contacts
%U https://www.nrao.edu/meetings/isstt/2008.shtml
%P 62-67