%0 Journal Article
%T Effects of thermal annealing on the microstructure of sputtered Al2O3 coatings
%A Edlmayr, V.
%A Harzer, T. P.
%A Hoffmann, R.
%A Kiener, D.
%A Scheu, C.
%A Mitterer, C.
%J J. Vac. Sci. Technol. A
%D 2011
%V 29
%N 4
%F Edlmayr_etal2011
%O Annealing
%O exported from refbase (https://db.rplab.ru/refbase/show.php?record=693), last updated on Sun, 22 May 2016 17:15:50 -0500
%X The morphology and microstructure of Al2O3 thin films deposited by pulsed direct current magnetron sputtering were studied in the as-grown state and after vacuum annealing at 1000 °C for 12 h using transmission electron microscopy. For the coating deposited under low ion bombardment conditions, the film consists of small γ- and/or δ-Al2O3 grains embedded in an amorphous matrix. The grain size at the region close to the interface to the substrate was much larger than that of the remaining layer. Growth of the γ-Al2O3 phase is promoted during annealing but no transformation to α-Al2O3 was detected. For high-energetic growth conditions, clear evidence for γ-Al2O3 formation was found in the upper part of the coating with grain size much larger than for low-energetic growth, but the film was predominately amorphous at the interface region. Annealing resulted in the transformation of γ-Al2O3 to α-Al2O3, while the mainly amorphous part crystallized to γ-Al2O3.
%K Annealing
%P 8