| Home | << 1 2 3 >> |
|
| Records | |||||
|---|---|---|---|---|---|
| Author | Khosropanah, Pourya | ||||
| Title | NbN and NbTiN hot electron bolometer THz mixers | Type | Book Whole | ||
| Year | 2003 | Publication | Chalmers University of Technology | Abbreviated Journal | |
| Volume | Issue  |
Pages | |||
| Keywords | HEB mixer, hot electron bolometer mixer, NbN, NbTiN, superconducting detector, heterodyne receiver, THz mixer, submillimeter mixer, quasioptical receiver, double slot antenna, twin slot antenna, spiral antenna, receiver noise, FTS, Fourier Transform Spectrometer | ||||
| Abstract | The thesis reports the development of Hot Electron Bolometer (HEB) mixers for radio astronomy heterodyne receivers in THz frequency range. Part of this work is the fabrication of HEB devices, which are based on NbN or NbTiN superconducting thin films (â‰<a4>5 nm). They are integrated with wideband spiral or double-slot planar antennas. The mixer chips are incorporated into a quasi-optical receiver. The experimental part of this work focuses on the characterization of the receiver as a whole, and the HEB mixers as a part. Double side band receiver noise temperature and the IF bandwidth are reported for frequencies from 0.7 THz up to 2.6 THz. The spectrum of the direct response of HEB integrated with dierent antennas are measured using Fourier Transform Spectrometer (FTS). The effect of the bolometer size on total receiver performance and the LO power requirements is also discussed. A high-yield and reliable process for fabrication of NbN HEB mixers have been achieved. Over 100 devices with different bolometer geometry, film property and also different antennas have been fabricated and measured. The measured data enables us to discuss the impact of different parameters to the receiver overall performance. This work has provided NbN HEB mixers to the following receivers: TREND (Terahertz REceiver with NbN HEB Device) operating at 1.25-1.5 THz, installed in AST/RO Submillimeter Wave Telescope, Amundsen/Scott South Pole Station, in 2002-2003. Band 6-low (1.410-1.700 THz) and 6-high (1.700-1.920 THz) of the HIFI (Heterodyne Instrument for Far Infra-red) in the Herschel Space Observatory, due to launch in 2007 by ESA (European Space Agency). Besides, there has been continuous efforts to develop better models to explain the mixer performance more accurately. They are based on two temperature model for electrons and phonons and solving one-dimensional heat balance equations along the bolometer. The principles of these models are illustrated and the calculated results are compared with measured data. |
||||
| Address | |||||
| Corporate Author | Thesis | Ph.D. thesis | |||
| Publisher | Chalmers University of Technology | Place of Publication | Göteborg | Editor | |
| Language | Summary Language | Original Title | |||
| Series Editor | Series Title | Abbreviated Series Title | |||
| Series Volume | Series Issue | Edition | |||
| ISSN | ISBN | Medium | |||
| Area | Expedition | Conference | |||
| Notes | Approved | no | |||
| Call Number | Serial | 910 | |||
| Permanent link to this record | |||||
| Author | Bennett, Douglas A.; Schmidt, Daniel R.; Swetz, Daniel S.; Ullom, Joel N. | ||||
| Title | Phase-slip lines as a resistance mechanism in transition-edge sensors | Type | Journal Article | ||
| Year | 2014 | Publication | Appl. Phys. Lett. | Abbreviated Journal | Appl. Phys. Lett. |
| Volume | 104 | Issue |
Pages | 042602 | |
| Keywords | microbolometers, TES, phase-slip lines, PSL | ||||
| Abstract | The fundamental mechanism of resistance in voltage-biased superconducting films is poorly understood despite its importance as the basis of transition-edge sensors (TESs). TESs are utilized in state-of-the-art microbolometers and microcalorimeters covering a wide range of energies and applications. We present a model for the resistance of a TES based on phase-slip lines (PSLs) and compare the model to data. One of the model's predictions, discrete changes in the number of PSLs, is a possible explanation for the observed switching between discrete current states in localized regions of bias. | ||||
| Address | |||||
| Corporate Author | Thesis | ||||
| Publisher | Place of Publication | Editor | |||
| Language | Summary Language | Original Title | |||
| Series Editor | Series Title | Abbreviated Series Title | |||
| Series Volume | Series Issue | Edition | |||
| ISSN | ISBN | Medium | |||
| Area | Expedition | Conference | |||
| Notes | Recommended by Klapwijk | Approved | no | ||
| Call Number | Serial | 929 | |||
| Permanent link to this record | |||||
| Author | Maslennikov, S. | ||||
| Title | RF heating efficiency of the terahertz superconducting hot-electron bolometer | Type | Journal Article | ||
| Year | 2014 | Publication | arXiv | Abbreviated Journal | arXiv |
| Volume | 1404.5276 | Issue |
Pages | 1-4 | |
| Keywords | superconducting hot-electron bolometer mixer, HEB, NbN, distributed model, HEB model, HEB mixer model, heat balance equa-tions, conversion gain, RF heating efficiency, noise temperature, simulation, Euler method | ||||
| Abstract | We report results of the numerical solution by the Euler method of the system of heat balance equations written in recurrent form for the superconducting hot-electron bolometer (HEB) embedded in an electrical circuit. By taking into account the dependence of the HEB resistance on the transport current we have been able to calculate rigorously the RF heating efficiency, absorbed local oscillator (LO) power and conversion gain of the HEB mixer. We show that the calculated conversion gai nis in excellent agreement with the experimental results, and that the substitution of the calculated RF heating efficiency and absorbed LO power into the expressions for the conversion gain and noise temperature given by the analytical small-signal model of the HEB yields excellent agreement with the corresponding measured values | ||||
| Address | |||||
| Corporate Author | Thesis | ||||
| Publisher | Place of Publication | Editor | |||
| Language | Summary Language | Original Title | |||
| Series Editor | Series Title | Abbreviated Series Title | |||
| Series Volume | Series Issue | Edition | |||
| ISSN | ISBN | Medium | |||
| Area | Expedition | Conference | |||
| Notes | Approved | no | |||
| Call Number | RPLAB @ atomics90 @ | Serial | 954 | ||
| Permanent link to this record | |||||
| Author | Tovpeko, N. A.; Trifonov, A. V.; Semenov, A. V.; Antipov, S. V.; Kaurova, N. S.; Titova, N. A.; Goltsman, G. N. | ||||
| Title | Bandwidth performance of a THz normal metal TiN bolometer-mixer | Type | Conference Article | ||
| Year | 2019 | Publication | Proc. 30th Int. Symp. Space Terahertz Technol. | Abbreviated Journal | Proc. 30th Int. Symp. Space Terahertz Technol. |
| Volume | Issue |
Pages | 102-103 | ||
| Keywords | TiN normal metal bolometer, NMB | ||||
| Abstract | We report on the bandwidth performance of the normal metal TiN bolometer-mixer on top of an Al 2 O 3 substrate, which is capable to operate in a wide range of bath temperatures from 77 K – 300 K. The choice of the combination TiN / Al 2 O 3 is related to an advanced heat transport between the film and the substrate in this pair and the sufficient temperature coefficient of resistance. The data were taken at 132.5 – 145.5 GHz with two BWOs as a signal and an LO source. Measurements were taken on TiN films of different thickness starting from 20 nm down to 5 nm coupled into a spiral Au antenna, which improves matching of incoming radiation with the thin TiN fim. Our experiments demonstrate effective heat coupling from a TiN thin film to an Al 2 O 3 substrate (111) boosting gain bandwidth (GB) of TiN bolometer up to 6 GHz for 5 nm thin film. Current results indicate weak temperature dependence of GB on the bath temperature of the TiN bolometer. Theoretical estimations of GB performance meet with experimental data for 5 nm thin TiN films. | ||||
| Address | |||||
| Corporate Author | Thesis | ||||
| Publisher | Place of Publication | Editor | |||
| Language | Summary Language | Original Title | |||
| Series Editor | Series Title | Abbreviated Series Title | |||
| Series Volume | Series Issue | Edition | |||
| ISSN | ISBN | Medium | |||
| Area | Expedition | Conference | |||
| Notes | Approved | no | |||
| Call Number | Serial | 1279 | |||
| Permanent link to this record | |||||
| Author | Ryabchun, S.; Tong, C.-yu E.; Blundell, R.; Kimberk, R.; Gol’tsman, G. | ||||
| Title | Effect of microwave radiation on the stability of terahertz hot-electron bolometer mixers | Type | Conference Article | ||
| Year | 2006 | Publication | Proc. SPIE | Abbreviated Journal | Proc. SPIE |
| Volume | 6373 | Issue |
Pages | 63730J (1 to 5) | |
| Keywords | NbN HEB mixers, hot-electron bolometer mixers, stability, Allan variance, LO power fluctuations | ||||
| Abstract | We report our studies of the effect of microwave radiation, with a frequency much lower than that corresponding to the energy gap of the superconductor, on the performance of the NbN hot-electron bolometer (HEB) mixer incorporated into a THz heterodyne receiver. It is shown that exposing the HEB mixer to microwave radiation does not result in a significant rise of the receiver noise temperature and degradation of the mixer conversion gain so long as the level of microwave power is small compared to the local oscillator drive. Hence the injection of a small, but controlled amount of microwave radiation enables active compensation of local oscillator power and coupling fluctuations which can significantly degrade the stability of HEB mixer receivers. | ||||
| Address | |||||
| Corporate Author | Thesis | ||||
| Publisher | SPIE | Place of Publication | Editor | Anwar, M.; DeMaria, A.J.; Shur, M.S. | |
| Language | Summary Language | Original Title | |||
| Series Editor | Series Title | Abbreviated Series Title | |||
| Series Volume | Series Issue | Edition | |||
| ISSN | ISBN | Medium | |||
| Area | Expedition | Conference | Terahertz Physics, Devices, and Systems | ||
| Notes | Approved | no | |||
| Call Number | Serial | 1441 | |||
| Permanent link to this record | |||||